The use of laboratory reactor must be closed refrigerant inlet pipe valve, and put pot and clip refrigerant remaining in the sleeve, and then enter the material, start the blender, then open the steam valve and the electric power supply, to reach the required temperature, should first close the steam valve and the electric power supply, 2~3 minutes later, and then close the blender. After processing, the jacket and put the remaining condensed water, should rinse with warm water, brush off a sticky material, and then use the 40~50 0 C base on the inner wall of the container clean, rinse with water, especially the no material (heat absorption medium) empty pot case, shall open the steam valve and electric heating pay special attention to the use of power, steam pressure, working pressure shall not exceed the quota.

Maintenance laboratory reactor should always pay attention to the whole equipment and deceleration device, reducer lubrication oil shortage should be immediately added, the electric heating medium oil every six months to replace, the clamping sleeve and the upper cover parts of the safety valve, pressure gauge, thermometer, distilled hole, electric rods, electrical instruments, such as to should be checked regularly, if there is a fault to immediate replacement or repair, equipment when not in use, must use warm water in the inner and the outer walls of the container comprehensive cleaning, regular cleaning of the pot body, keep clean appearance and inner light, to achieve the purpose of durability.

  双语对照